Mitsubishi Electric LT-37132 Owner's Manual page 48

48
Chapter 3. TV Setup
Additional Setup Using the
NetCommand Menu, continued
4. Highlight the text box under AV RECEIVER SETUP.
5. Confirm that the setting is at None, the default.
This setting tells the TV to automatically transfer VCR
audio to the A/V receiver. The TV converts analog
audio to digital for ouput to a digital A/V receiver.
6. Press EXIT to close all menus.
���������
������������
��
Audio Available from TV Only (see figure 18)
1. Press INPUT to display the Input Selection menu.
2. Highlight the icon for an antenna input (ANT 1 or
ANT 2) and press ENTER to switch to the input. Select
an antenna input in this step even if you have a cable
box or satellite receiver connected on the HDMI,
COMPONENT, or INPUT jacks.
3. Press MENU and open the NetCommand menu.
4. Highlight the text box under AV RECEIVER SETUP.
to move through the list to TV. This is the list
5. Press
of A/V receiver inputs you named in the AV Receiver
(AVR) Learn screen (see figure 15).
The TV setting here indicates that audio out from
the TV (DIGITAL AUDIO OUT or AUDIO OUT
LEFT/RIGHT) is sent to the A/V receiver's TV
AUDIO input. Audio from ANT 1 and ANT 2 and
IMPORTANT
To hear audio that is sent from the TV to the A/V
receiver, you must have:
• physically connected the TV to the A/V receiver
• learned the IR codes for the A/V receiver inputs
• chosen the correct input under NetCommand
AV RECEIVER SETUP
• selected the A/V receiver for audio in the Input
Selection menu
Figure 17, left and below. A/V
receiver setup indicating the
analog VCR's audio output is
automatically sent to the A/V
receiver via the TV's audio
output.
�����������
�������������
�������
������������
���������
����������
�����
�����
������������
IEEE 1394 devices must go to the A/V receiver from
the TV's audio outputs as there is no way to send the
audio directly to the A/V receiver.
6. Press EXIT to close all menus.
��
Digital Surround Sound (see figure 19)
1. Press INPUT to display the Input Selection menu.
2. Highlight the icon for the DVD player and press ENTER
to switch to the DVD input.
3. Press MENU and open the NetCommand menu.
4. Highlight the text box under AV RECEIVER SETUP.
5. Press to move through the list to DVD.
This setting tells the TV that digital surround sound
from the DVD player is connected directly to the A/V
receiver's DVD AUDIO input.
6. Press EXIT to close the screen.
Figure 18, Left and below. A/V
receiver setup indicating that the
TV's audio output (DIGITAL
AUDIO OUT or AUDIO OUT
LEFT/RIGHT) is connected
to the A/V receiver's TV audio
input.
Figure 19, left and below. A/V
receiver setup indicating the
DVD player's audio output is
connected directly to the A/V
receiver's DVD audio input.