Mitsubishi Electric LT-37132 Owner's Manual page 113

Appendix D: Troubleshooting, continued
Picture
Symptom
9. Screen is black when trying to view digital
channels or IEEE 1394 device.
10. DVCR analog/digital problems.
11. Cannot see a picture from a DV Camcorder.
Indicators
Symptom
Status indicator light is a steady/flashing red. Service may be required. Turn off the TV and unplug the set
Sound
Symptom
1. There is no sound even when the volume is
turned up.
2. The sound does not match the screen
picture.
Remarks
The PerfectColor™ color balance has been incorrectly set. Press
VIDEO repeatedly until you see the PerfectColor option and press
ENTER to open the PerfectColor ™ menu.
If the tape is currently playing but no picture displays, there
may be a mismatch of the media with the display. Press INPUT
to display the Input Selection menu. Press ENTER for the DVCR
device. If digital is selected, try analog, or if analog is selected, try
digital.
Use analog connections for video and audio. You can still use the
IEEE 1394 connection for control functions, however.
Remarks
from the AC power source. Wait one minute and then plug the set
back in.
If the LED is still on, contact your dealer or a Mitsubishi Autho-
rized Service Center. See www.mitsubishi-tv.com or call
1-800-332-2119 to receive Authorized Service Center information.
Remarks
Check if the MUTE button is on.
•
• The TV's "Listen to:" setting may be set to SAP.
• Check that the TV Speakers setting is On in the Audio/Video
menu.
• If using an A/V receiver, check audio source in Input Selection
menu.
• Perform a System Reset.
• The TV's Listen to: setting may be set to SAP.
• If using stereo or A/V receiver speakers, check their input
selection.
• If using stereo or A/V receiver, check that AUDIO OUTPUT
LEFT/RIGHT or DIGITAL AUDIO OUTPUT on TV's back panel
is connected to the A/V receiver.
Appendices Appendices
113 113