Table of Contents
Advertisement
The media settings include the options selected and stored for each media bank or RIP setting you
created.
1. Do one of the following:
• If the displayed media settings are correct for the media you loaded, press the up or down arrow
button to select Keep Settings Above and press the OK button.
• If you need to change the media settings, press the up or down arrow button to select Change
Settings and press the OK button.
2. If you want your product to calculate the amount of media remaining based on the length of the roll
and the amount already printed, and display the approximate results on the product control panel,
set the Remaining Setup setting to On.
3. To change your media settings, select the setting you want to change and press the OK button.
Then press the
back button and repeat this step to select additional settings as necessary.
4. When you finish changing media settings, press the up or down arrow button to select Keep
Settings Above and press the OK button.
You see the roll type selection screen.
5. Press the up or down arrow button to select the roll type you loaded and press the OK button.
If you turned on the Remaining Setup setting, you see a prompt to enter the length of the current
media.
6. Press the up or down arrow button to select a roll length from 3 to 3280 feet (1 and 999.5 m) long
and press the OK button.
Note: You can select the roll length in 19.7 inch (0.5 m) increments.
After a moment you see the message Ready on the product control panel indicating that it is ready
to print.
Parent topic:
Media Handling
Related references
Media Setup Menu Settings
Related tasks
Saving Sets of Media Settings
37
Advertisement
Table of Contents
