Turning Off The Alarm - LENCO CR-16 User Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

6-7 :

Saturday & Sunday

1-1 :

One day of week (you need to further select 1 for

Monday, 2 for Tuesday and so on)

5. Tap the ALARM 1 (or ALARM 2) button again to advance to

select the Alarm source between Beeper or Radio.

Notes:

When the Beeper alarm begins, it will sound at a lower

beeping rate and gradually increase to the normal rate within

30 seconds.

If you want to choose radio as the alarm source, you need to

set the radio to your desired radio station in radio mode first.

After selecting the Radio as the alarm source during alarm

setting, you need to select FM radio and the preset alarm

volume level (up to maximum level 15). When the radio is

turned 'On' at the preset alarm time, the radio will begin to

sound at a low volume and gradually increases to the preset

volume level.

Note: it is not possible to adjust the volume level during the radio

alarm. If volume adjustment is needed, you must turn 'Off' the

radio first, and then turn it 'On' again using the POWER ON-OFF

button. The alarm will also be stopped immediately.

6. Press the ALARM 1 (or ALARM 2) button to finish setting and

exit to normal time display.

7. To disable ALARM 1 (or ALARM 2) from automatically

sounding on the upcoming days, press and hold the ALARM

1 (or ALARM 2) button for about 2 seconds, the corresponding

ALARM 1 (or ALARM 2) INDICATOR will go off.

8. To resume ALARM 1 (or ALARM 2) from automatically

sounding on the upcoming days, press and hold the ALARM

1 (or ALARM 2) button for about 2 seconds, the corresponding

ALARM 1 (or ALARM 2) INDICATOR will turn on and the alarm

will sound the following day at the set time.