Mitsubishi MSZ09UN Operating Instructions Manual page 17

AIR FLOW VELOCITY AND DIRE
AIR FLOW velocity and direction can be selected
as required.
CLOCK
TOO
ON/OFF
WARM
FAN
I FEEL COOL
VANE
HEAT DRY
MODE
RESET CLOCK
I
•
Use the
•
If the operating sound of the air conditioner disturbs your
sleep, use the
I
˚C
AMPM
AMPM
SWING OPERATION
TOO
COOL
Use the swing operation for the air flow to reach all cor-
ners of the room.
Recommended horizontal
vane range
STOP
Use the
ally.
Use position
START
COOL or DRY mode and use posi-
tions (3) to (5) in the HEAT mode
when adjusting to your require-
HR.
ments.
MIN.
NOTE
I In the cooling operation, when the air conditioner is op-
erated with setting the horizontal vane to
1 hour, the AIR FLOW direction is automatically set to
horizontal to prevent condensed water from dropping.
I Adjust the vertical AIR FLOW direction using the remote
controller. If the horizontal vane is moved manually, it
may cause trouble.
I In the heating operation, if the air flow temperature is
too low or when defrosting is being done, the horizontal
vane position is set to
To change the AIR FLOW velocity, press
FAN
the button.
Each time the button is pressed, the fan speed is
changed in sequence: (Low) →
→
(AUTO)
(High) notch to cool/heat the room more.
(Low) notch.
To change the AIR FLOW blowing direc-
tion vertically, press the
Each time the button is pressed, the angle of the hori-
zontal vane is changed in sequence:
(3) → (4) → (5) → (SWING) →
(AUTO) position usu-
(1) or (2) in the
(1).
(Med.) →
(High)
VANE
button.
(1) → (2) →
(AUTO)
1
COOL
2
DRY
3
4
HEAT
5
(4) or (5) for