Flashtool Für Planatron - Grundig Planatron PW 110-520/9 PAL PLUS Service Manual

Hide thumbs Also See for Planatron PW 110-520/9 PAL PLUS:
Table of Contents

Advertisement

Planatron PW 110-520/9 PALplus
Flashtool für Planatron
Hinweis: Um die Software auf den aktuellen Stand zu bringen (z.B.
nach Tausch der Grundplatte Signal Feature), sind folgende Service-
arbeiten durchzuführen:
– EPROM (IC80530) auf der Grundplatte Signal Feature wechseln.
– Flash-EPROM im Chassis Digital mit neuer Software von der
Diskette(n) laden.
Vorbereitung
EPROM (IC80530) wechseln.
Diskette(n) auf Festplatte des Computers kopieren.
Serielle Schnittstelle des Computers mit der Westernbuchse des
Planatron verbinden (Adapterkabel).
Programm starten.
Bei Windows 3.1 wird eventuell ein Fenster geöffnet, in welchem Sie
zu einem Update des Treibers aufgefordert werden.
Ausführung erfolgt durch Anklicken des Schalters "Installieren" (rote
Schrift).
Im Dateimenü ist über den Menüpunkt "Sprache/Language" die Spra-
che einzustellen.
Über Menüpunkt "Optionen/Grundeinstellungen" müssen Schnittstel-
le und Übertragungsgeschwindigkeit eingestellt werden.
Übertragungsrate mit 57.600 Baud beginnen, bei fehlerhafter Übertra-
gung schrittweise zurückgehen.
GRUNDIG Service
Flashtool for Planatron
Note: For updating the software (e.g. on replacement of the Basic
Board Signal Feature), carry out the following service works:
– Replace EPROM (IC80530) on the Basic Board Signal Feature.
– Load the new software from the diskette(s) into the Flash-EPROM
on the Chassis Digital.
Preparation
Replace EPROM (IC80530).
Copy the diskette(s) onto the permanent disk memory.
Connect the computer serial interface with the Planatron Western
socket (adapter cable).
Start the programme.
With Windows 3.1 a window may open requesting you to update the
driver.
Updating is started by clicking on the switch "Installieren" (Install, red
text).
The language can be selected in the file menu, item "Sprache/
Language".
Via the menu item "Optionen/Grundeinstellungen" (options/default
settings) the interface and baud rate is to be selected.
Start with a rate of 57,600 Baud. When there is a fault in the transfer,
reduce the rate step by step.
Allgemeiner Teil / General Section
1 - 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Planatron pw 110-520/9 palplus

Table of Contents