Quick Start - NEC MultiSync EA275WMi User Manual

Quick Start

To connect the LCD monitor to your system, follow these instructions:
NOTE: Make sure to read "Recommended Use" (page 3) before installation.
1. Turn off the power of your computer.
2. For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system
(Figure A.1).
For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system
(Figure A.2). Tighten all screws.
For a PC with HDMI output: Connect the HDMI cable to the connector of the display card in your system (Figure A.3).
For a PC with Analog output: Connect a 15-pin mini D-SUB to DVI-A signal cable to the connector of the display card in
your system (Figure A.4).
For a MAC with Thunderbolt output: Connect a Mini DisplayPort to DisplayPort adapter (not included) to the computer,
then attached the included DisplayPort cable to the adapter and to the display (Figure A.5).
DisplayPort cable
Figure A.1
15-pin mini D-SUB to DVI-A signal cable*
NOTE: 1. When removing the DisplayPort cable, hold down the top button to release the lock.
2. Please use a High Speed HDMI cable with HDMI logo.
3. Please use a DisplayPort Certifi ed DisplayPort cable.
4. Some 15-pin D-SUB to DVI-A cable may not display an image correctly. See page 21, "No picture".
* 1 The type and number of cables included will depend on the where the LCD monitor is to be shipped.
1
DVI cable*
1
Figure A.4
Figure A.2
Macintosh Cable Adapter (not included) Macintosh Cable Adapter (not included)
English-6
HDMI cable (not included)
Figure A.3
Figure A.5