Advertisement
Before Seffing Surface Controls
Check Burner Cap Placement
Before Operating
the Surface
Burners
To prevent flare-ups
and avoid creation
of harmful
by-
products, do not use the cooktop without
aii burner caps
property
installed
to insure proper ignition and gas flame
size.
It is very
important
to be sure that aii surface
burner caps
and burner grates are property
installed
and in the correct
locations
BEFORE operating
the cooktop
burners.
Remember:
° Always
keep surface
burner caps in place whenever
using
a surface burner.
° When placing the burner caps, be sure that all burner caps
are seated firmly
and rest level on top of burner heads.
° For proper
flow of gas and ignition of burners DO NOT
aflow spills, food, cleaning
agents or any other material
to enter the gas orifice
port opening.
Round Style Burners
The burner cap lip (See Fig. 1) should fit snug into the center
of burner head and rest level. Refer to Figs. 2 & 3 for
correct
and incorrect
burner cap placement.
Once in place,
you may check the fit by gently
sliding the burner cap
from side to side (Fig. 4) to be sure it is centered
and firmly
seated. When the burner cap lip makes contact
inside the
center of the burner head you will be able to feel it. Please
note that the burner cap should NOT move off the center of
the burner head when sliding from side to side.
Burner Cap
Burner Head
_
_
"x_ Burner Cap Lip
Fig. 1
Double Ring Style Burners
The Double
Ring burner only operates
property
with two
burner caps in place.
Be sure the burner cap lips are
positioned
facing
down towards
the burner head (Fig. 5)
and into the recessed areas (Fig. 6) on each side of the
burner head. Be sure both burner caps are seated firmly
and
rest level on the burner head before operating.
Check the fit for each cap using the same method for the
round burner caps by gently
sliding each cap from side to
side. Please note that the burner cap lips should NOT move
out of recessed areas of the burner head.
Burner Caps
Recessed area
Burner Head
Fig. 5
Fig. 6
Correct
Burner Cap
Incorrect Burner Cap
Placement
Placement
Fig. 2
_
Fig. 3
Advertisement
