Advertisement
Setting Surface
Burner Controls
Setting the Turbo Boil Flex Twin Burner
The versatile Turbo Boil Flex Twin burner offers a complete
range of gas surface settings from the same burner position.
At the lowest setting, only the burner's inner ring is active,
providing
a smaller flame that is perfect
for simmering.
If
needed, the burner's outer ring may be added
and when set
for HI will provide a gas flame that may be used to bring a
large pan of liquid to boil quickly.
Operating
the Turbo Boil Flex Twin
Burner
1.
Place cooking
utensil on surface
burner.
2.
Push the surface
control
knob down and turn
counterclockwise
out of the OFF position
(See Figure 1).
3.
Release the knob and rotate
to the Life position.
4.
Visually
check that both the inner and outer rings for
the Twin burner are lit (See Figure 3). Once lit, turn the
control
knob and continue to turn counterclockwise
out
of the Lite position
and adjust to the desired flame
size.
5.
When adjusting
for a low or simmer type flame setting,
continue to rotate the control knob counterclockwise
from middle setting towards Lo (See Figure 1). Between
the middle
and Lo settings, the flame for the outer ring
portion
of the burner will turn off: leaving only the inner
burner with a flame for simmering
(See Figure 4). Make
any further flame adjustments
as needed.
Figure 2 - Twin Burner
Figure 3 - Inner and Outer rings lit
Figure 4 - Inner ring only lit
OFF
Life
Hi
Figure 1 - Twin Burner Control
1
Important
nares:
°
DO NOT cool< with the surface
control
knob left in the
LITE position.
(The electronic ignitor will continue
to spark
if the control
knob setting remains in the LITE position).
°
When setting any surface control
knob to the LITE
position, all electronic
surface ignitors
will spark at the
same time. However, only the surface burner you are
setting will ignite.
°
NEVER place or straddle
a cooking
utensil over two
different
surface
cooking
areas at the same time. This
can cause uneven heating
results.
11
Advertisement
