Connecting The Guitarface To Your Computer; Line Input; Instrument Input; Mic Input - Miditech Guitarface Owner's Manual

LINE out only carries the PC audio signal.

Connecting the Guitarface to your computer

Connecting the Guitarface to a computer is very easy! Simply connect your Guitarface, with the
included USB cable, to a free USB port on your computer. When the Guitarface is attached the
green LED lights up briefly to signal a good power supply to the Guitarface. The installation under
Windows will then take place automatically, a few seconds after connecting to your computer-
system it will find a "USB Audio Codec" or "USB Audio Device", which can be used in each
application and adjusted in the system control. Using the USB connection your digitized audio data
can now be transferred to your computer!

LINE input

Switch the input adjustment switch to "LINE". Connect your Player device with a stereo cable to
the 6,3mm TRS jack socket marked „Input". Now adjust the input-level with the little wheel next to
the input socket. You can connect any devices with a LINE level output, e.g. Tape deck or CD
players.

Instrument input

Switch the input adjustment switch to "GUITAR". Connect your electric guitar or bass with a mono
cable to the 6,3mm TRS jack socket marked „Input". Now adjust the input-level with the little
wheel next to the input socket. Note: the mono instrument will be played on both sides of the
headphone out.

MIC input

Switch the input adjustment switch to "MIC". Connect your dynamic microphone to the 6,3mm
TRS jack socket marked „Input". Now adjust the input-level with the little wheel next to the input
socket.

MIC with +48V phantom power input

ATTENTION!
Please firstly connect your condenser microphone with a symmetric microphone cable to the 6,3mm
TRS jack socket marked „Input". Switch the input adjustment switch to "+48V". Please note, that
switching the phantom power on makes a noise, that can damage your speaker system. Please
REDUCE THE LEVEL of your amplifier BEFORE switching to "+48V"! After one minute the
phantom power is ready to work! Now adjust the input-level with the little wheel next to the input
socket.

Signal and peak indicator LEDs

The two LEDS indicate an incoming audio signal to the Guitarface. With a correct level the green
signal LED lights up. The red peak LED only lights up when the signal level is too high, use the
input level wheel to adjust the signal level down to just below peak

LINE-Output (Stereo RCA Jacks)

Connect your amplifier to these outputs for monitor recordings or sounds from the computer.

Headphone-Output (Stereo Mini Jack 3,5 mm)

Connect your headphone to this output to monitor recordings or sounds from the computer.
References to the driver attitude under Windows audio sequencer programs such as Cubase,
sonar or Samplitude:
The Guitarface runs under hard disk recording programs in the "Full Duplex Mode" (simultaneous
admission and rendition) usually only with ASIO Multimedia drivers, the Windows WDM driver
only permits one direction (admission or rendition) at the same time. We recommend that you
download the Guitarface ASIO driver from our homepage www.miditech.de, or use the "ASIO for
ALL" driver for the Audioface under Windows XP. The ASIO driver makes it possible to use