Honda Accord Hybrid 2015 Quick Reference Manual page 337

uuHomeLink® Universal Transceiver
■
Training a Button
1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the
HomeLink button you want to program.
2.
Press and hold the desired HomeLink button and the button on
the remote transmitter. Does the HomeLink indicator (LED)
blink after 10 secs?
YES
3.
Press and hold the
programmed HomeLink
button for about a sec.
Does the device (garage
door opener) work?
YES NO
4. Press and hold the HomeLink button again.
Training
HomeLink LED
Complete
is on.
5.
Press and hold the HomeLink
button again.
The remote-controlled device
should operate.
Training Complete
336
* uTraining HomeLink
NO
a.
Press and hold the remote and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
YES
press and release the button on the remote
every 2 secs.
Does the LED blink within 20 secs?
HomeLink indicator blinks for 2 secs,
then remains on.
a.
The remote has a rolling code. Press the
"learn" button on the remote-controlled
device (e.g. garage door opener).
b.
Within 30 secs, press and hold the
programmed HomeLink button for 2 secs.
1Training HomeLink
Retraining a Button
If you want to retrain a programmed button for a
new device, you do not have to erase all button
memory. You can replace the existing memory code
using this procedure:
1. Press and hold the desired HomeLink button
NO
Standard transmitter
Indicator remains on
for about 25 secs.
2. Continue to hold the HomeLink button and
Erasing Codes
To erase all the codes, press and hold the two outside
buttons until the HomeLink indicator begins to blink
(about 10 to 20 secs). You should erase all codes
before selling the vehicle.
If you have any problems, see the device's
instructions, visit www.homelink.com, or call
HomeLink at (800) 355-3515.
I n f o r ma t i o n P r o v i d e d b y :
until the HomeLink indicator begins to blink.
Rolling code transmitter
Indicator blinks rapidly for
2 secs, then remains on for
about 23 secs.
follow steps 1 - 3 under "Training a Button."