Mb-430 Mobile Bracket; Rc-2000 Remote Panel - Kenwood TS-2000 Instruction Manual

17 INSTALLING OPTIONS

MB-430 MOBILE BRACKET

When installing the MB-430, attach the supplied
plastic spacers (G11-2698-XX) to the metal plates
that come with the MB-430. This is necessary to
protect the TS-2000(X)/ TS-B2000 from scratches.
Once the bracket is installed onto the vehicle,
prepare the transceiver by loosely screwing in the
rear screws. Hook those screws onto the rear guide
rail of the mounting bracket then adjust the
transceiver to your desired angle before tightening
the screws. Insert and tighten the front screws to
secure the transceiver in place.
Rear screw
Front screw
To remove the transceiver from the bracket, first
remove the front screws, then loosen the rear screws
slightly and pull the transceiver forward to unlatch it
from the bracket.
Do not install the transceiver so that it is vertically on its side.
98
G11-2698-XX
Make sure the tab faces out
Rear screw
Front screw

RC-2000 REMOTE PANEL

Plug the modular cable from the RC-2000 into the
PANEL connector on the TS-2000(X)/ TS-B2000 rear
panel. Access Menu No. 58 ~ 60 to adjust the panel
configuration if necessary.
TS-2000/ TS-2000X
TS-B2000