Table of Contents
Advertisement
• Replace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or
higher). Speak your local Service Force Centre.
The appliance must have the electrical installation which lets you disconnect the appliance
from the mains at all poles with a contact opening width of minimum 3 mm.
You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips and contactors.
Sticking on the seal
• Clean the worktop in the area of the cut-out section.
• Bond the sealing tape to the lower edge of the cooking surface along the outer edge of
the glass ceramic. Do not extend it. Let stay the cut ends in the middle of one side. When
you have cut it to length (add some mm), push the two ends together.
Assembly
min. 500 mm
min.
50 mm
min.
5 mm
R 5
mm
880
380
+1 mm
5
Installation
min.
50 mm
600
mm
+1 mm
Advertisement
Table of Contents
