Active Care Medical Spitfire 1310 Owner's Manual page 25

Questions? Call 866.621.4933 or visit www.activecaremed.com.
The diagnostic flash codes for your scooter are designed to help you perform basic
troubleshooting quickly and easily. A diagnostic flash code flashes from the
diagnostic light in the event one of the conditions listed below develops.
Table 2: Scooter Controller Internal Diagnostics
Flash Possible Cause
code
1 The battery needs charging
or there is a bad connection
to the battery.
2 There is a bad connection to
the motor.
3 The motor has a short circuit
to a battery connection.
4 Not available
5 Not available
6 The controller is being
inhibited from driving.
7 A speed control lever fault is
indication.
8 A controller fault is
indicated.
9 The parking brake has a bad
connection.
10 Excessive voltage has been
applied to the controller.
Spitfire Owner's Manual
Solution
Check the connections to the
battery. If the connections
are good, try charging the
battery.
Check all connections
between the motor and the
controller.
Please contact your
Authorized Service Center.
Check the battery charger
connector.
Remove the battery charger
from the scooter.
Make sure that the speed
control lever is in the rest
position before switching on
the scooter.
Make sure that all
connections are secure.
Check the parking brake and
motor connections. Make
sure the controller
connections are secure.
Check the battery
connections. This is usually
caused by a poor battery
connection.
24