Installation; Setup Suggestions; Initial Setup - Black Box Voice Magic Plus User Manual

3.1 Setup Suggestions

• Prepare a written list of the names and phone numbers you want to use for
voice-dial contacts before you start the setup procedure.
• When speaking into the Voice Magic Plus, do so in a relaxed tone of voice, at
your normal pace and loudness.
• To be sure that the system accurately recognizes voice commands, do not
answer voice prompts immediately. Instead, wait at least three seconds before
responding verbally to a Voice Magic Plus voice prompt.
• While connected to the Voice Magic Plus, you cellular phone's keypad is
inactive. Therefore, all keypad entry instructions refer to the keypad on the
Voice Magic Plus remote control, not the cellular phone.

3.2 Initial Setup

1. Connect the Voice Magic Plus's phone cable to your cellular phone, making
sure it fits into place for proper electrical contact and strain relief.
2. Connect the power cable to the Voice Magic Plus. Plug the other end into the
cigarette lighter receptacle.
3. To secure the microphone/infrared receiver in front of you on the
dashboard, use adhesive tape. (See Figure 3-1 on the next page.)
4. Press the power switch on your cellular phone to turn it on. Some vehicles
won't send power to the cigarette-lighter assembly unless the car is running or
the key is turned to an accessory-mode position.

3. Installation

CHAPTER 3: Installation
9