Rear Panel - versa VX-AP310N User Manual

Rear Panel

Reset Button
ETHERNET
Power port
CONSOLE
Figure 3: Rear Panel
This button has two (2) functions:
Reboot. When pressed and released, the Wireless Access Point
will reboot (restart).
Reset to Factory Defaults. This button can also be used to clear
ALL data and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Hold the Reset Button until the Status (Red) LED blinks TWICE,
usually more than 5 seconds.
2. Release the Reset Button.
The factory default configuration has now been restored, and the
Access Point is ready for use.
Use a standard LAN cable (RJ45 connectors) to connect this port to a
10/100/1000BaseT hub/switch on your LAN.
Connect the supplied power adapter (12V@1A) here.
DB9 female RS232 port.
Introduction
5