versa VX-AP310N User Manual page 20

Wireless Access Point User Guide
Operation Mode
Remote MAC
Address
Select Remote
AP
Select the desired mode:
Access Point - operate as a normal Access Point
Bridge (Point-to-Point) - Bridge to a single AP. You must
provide the MAC address of the other AP in the PTP Bridge AP
MAC Address field.
Bridge (Multi-Point) - Select this only if this AP is the "Master"
for a group of Bridge-mode APs. The other Bridge-mode APs
must be set to Point-to-Point Bridge mode, using this AP's MAC
address. They then send all traffic to this "Master".
Wireless Client/Repeater - Act as a client or repeater for another
Access Point. If selected, you must provide Remote SSID and the
address (MAC address) of the other AP in the Remote AP MAC
Address field. In this mode, all traffic is sent to the specified AP.
Wireless Detection - This mode will turn the access point into a
wireless Monitor. A "Rouge AP" is an Access Point which should
not be in use, and so can be considered to be providing unauthor-
ized access to your LAN.
No Security - If checked, then any AP operating with security
disabled is considered to be a Rogue AP.
Not in Legal AP List - If checked, then any AP not listed in
the "Legal AP List" is considered to be a Rogue AP. If
checked, you must maintain the Legal AP List.
Define Legal AP - Click this to open a sub-screen where you
can modify the "Legal AP List". This list must contain all
known APs, so must be kept up to date.
You must enter the MAC address(es) of other AP(s) in the fields.
If the other AP is on-line, you can click the "Select Remote AP" button
and select from a list of available APs.
16