Setting Up The Focus 3-Mode; To Search For Your Television Code - ADB FOCUS 3-MODE Instruction Booklet

Hide thumbs Also See for FOCUS 3-MODE:
Table of Contents

Advertisement

Setting up the FOCUS 3-MODE

1.
Make sure your device (television) you wish to operate is switched on (not in standby).
2.
Find the code for your device in the Code List (In the back of this manual). The device
codes are listed per device type and brand name. Also the most popular code for each
brand is listed first (Note: If your brand is not listed at all, try the Search Method below)
3.
Press the device mode key (e.g. TV) on the Focus remote for the device you wish to set up.
4.
Press and hold down SHIFT until the red light blinks twice (the red light will blink once
then twice).
5.
Enter your four-digit device code using the number keys. The red light will blink twice.
6.
Now aim the FOCUS 3-MODE remote at your device (television) and press POWER. If your
device switched off, the FOCUS 3-MODE is ready to operate your device.
Most TV' s do not switch back on pressing the POWER key, please try pressing a "number" key
or the "TV-text off" key to switch your TV back on. -If your device does not respond, follow steps
1 through 6 with each code listed for your brand. If none of the codes listed for your brand
operate your device, then try the Search Method described below, even if your brand is not
listed at all. -Some codes are quite similar. If your device does not respond or is not functioning
properly with one of the codes, try another code listed under your brand. -If the original remote
control from your Video Recorder / DVD player did not have a POWER key, press PLAY instead
of POWER during step 6. -To set up your other devices, follow the same instructions above, only
press the appropriate device key during step 3. -Remember to press the correct device key
before operating your device. Only one device can be assigned to a device key.
Write your device code in the applicable four digit boxes provided in the battery
compartment and on page 8 for future reference.
Step and Set Search Method
If your device does not respond to the FOCUS 3-MODE after you have tried all the codes listed
for your brand.
If your brand is not listed at all, the Search Method allows you to scan through all the codes
contained n the memory of the FOCUS 3-MODE.

To Search for your Television Code

1.
Switch your television on (not in standby mode).
2.
Press the TV key on the FOCUS 3-MODE.
3.
Press and hold down SHIFT key until the red light blinks twice (the red light will blink once
then twice).
4.
Press 9 9 1. The red light will blink twice.
5.
Next, press a function. *
6.
Aim the FOCUS 3-MODE at your Television. Now press PROG+ over and over, in order to
scan through the codes available in the memory. You may have to press this key many
times (up to 150 times) so please be patient. If you skip past a code, you can go to the
previous code(s) by pressing the PROG-key. Remember to keep pointing the FOCUS
3-MODE at your Television while pressing this key. **
7.
As soon as you have found an appropriate code, press SHIFT key to store the code.
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FOCUS 3-MODE and is the answer not in the manual?

Related Products for ADB FOCUS 3-MODE

Table of Contents