Headlight Beam Adjustment; Brake Lights - Polaris 2016 RANGER EV Li-Ion Owner's Manual

MAINTENANCE
Lights

Headlight Beam Adjustment

1. Place the vehicle on a level
surface with the headlight
approximately 25 ft. (7.6 m)
from a wall.
2. Measure the distance from the
floor to the center of the
headlight and make a mark on
the wall at the same height.
3. Apply the brakes. Turn the
key to the LIGHTS ON
position.
4. Observe the headlight aim.
The most intense part of the headlight beam should be
aimed 8" (20 cm) below the mark placed on the wall.
Include the weight of a rider on the seat while performing
this step.
5. If a headlight needs adjustment, access the adjustment
screw under the hood or through the wheel well.
6. Loosen the screw, adjust the headlight, and tighten the
screw.
7. Repeat steps 4-6 until the lamp is properly adjusted.

Brake Lights

When the brake pedal is depressed, the brake light comes on. Check the brake light before
each ride.
1. Turn the key on.
2. Depress the brake pedal. The brake light should come on after about 10 mm (0.4 in.) of
pedal travel. If the light doesn't come on, check the bulb.
Spring Adjustment
Adjust the rear shock absorber springs by rotating the adjustment cams
either clockwise or counter-clockwise to increase or decrease spring
tension.
60
X
25 ft.
(7.6 m)
X
8"(20 cm)
Adjustment
Screw
Cam