Omron BP785N User Manual page 34

HEM-7321-Z_C_M.book Page 31 Monday, June 16, 2014 12:09 PM
9. Guidance and Manufacturer's Declaration
OMRON BP785N including AC-adapter is intended for use in the electromagnetic environment specified below. The customer or the user of
this OMRON BP785N including AC-adapter should assure that it is used in such environment.
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short interruptions
and voltage variations on power
supply inputlines
IEC 61000-4-11
Downloaded from www.Manualslib.com
Power frequency (50/60 Hz)
Guidance and manufacturer's declaration - electromagnetic immunity
IEC 60601 test level
±6 kV contact
±8 kV air
±2 kV for power supply lines
±1 kV for input/output lines
±1 kV line(s) to line(s)
±2 kV line(s) to earth
<5 % U (>95 % dip in U
T
for 0.5 cycle
40 % U (60 % dip in U
T
for 5 cycles
70 % U (30 % dip in U
T
for 25 cycles
<5 % U (95 % dip in U
T
for 5 sec.
manuals search engine
Compliance level
±6 kV contact
±8 kV air
±2 kV for power supply lines
±1 kV for input/output lines
±1 kV line(s) to line(s)
±2 kV line(s) to earth
) <5 % U (>95 % dip in U
T T
for 0.5 cycle
) 40 % U (60 % dip in U )
T T T
for 5 cycles
) 70 % U (30 % dip in U )
T T T
for 25 cycles
) <5 % U (95 % dip in U )
T T T
for 5 sec.
Electromagnetic environment - guidance
Floor should be wood, concrete, or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30 %.
Mains power quality should be that of a typical
commercial and/or hospital environment.
Mains power quality should be that of a typical
commercial and/or hospital environment.
)
T
Mains power quality should be that of a typical
commercial and/or hospital environment. If the
user of the OMRON BP785N including AC-
adapter requires continued operation during
power mains interruption, it is recommended
that the OMRON BP785N including AC-adapter
be powered from an uninterruptible power
supply.
Power frequency magnetic fields should be at
EN