Basic Operation - Alinco DJ-FX446 Instruction Manual

Basic Operation

Function introduction
1. To turn on/off
Attach the battery pack. Turn on the power by turning the dial clockwise. A beep
sounds and the icons appear on the display. Turn the
dial counterclockwise gently until locks to turn off. Stop
rotating the dial when it's turned off otherwise the dial
may be damaged and cause malfunction.
2. To select channel and transmit
Press key to select a desired, clear channel to operate. All units in the
or
same group should use the same channel and same selective calling settings that
the instruction will follow. It is a good practice to monitor the channel to make sure
no one is using it before transmitting. Press
voice level.
Don't talk too loud, too undertone nor too close to
the microphone otherwise the audio may be distorted.
3. Scan function
Press and hold
or
on the display. While scanning, press another triangle key to change the scanning
direction. Press any key other than
Scan stops when a signal is detected, and resumes
scanning after the receiving signal is gone.
18
key for 2 seconds to start scanning. A scan icon appears
or
then start speaking in a normal
key to stop.