Table of Contents
Advertisement
Quick Links
Please read this manual carefully in order
to experience the full benefits of your lamp.
Please store the manual for later use.
USING THE LAMP
The charge of the lamp's battery will be reduced when the lamp is stored. The lamp must be carefully
charged prior to use by using a MICA ILC4 charging stand. The battery will be charged from empty
to full in 6 to 12 hours, depending on the temperature and condition of the battery. A new battery will
reach its full capacity when it has been fully charged and discharged about ten times. The first
charging of a new lamp must take at least 12 uninterrupted hours!
OPERATING MODES
A pushbutton controls the functions of different lamp models as follows:
IL-640: LOW-POWER -> FULL-POWER -> OFF
IL-640 EM: LOW-POWER -> FULL-POWER -> OFF. If the lamp is in the charging stand and a power
failure occurs, the lamp is automatically lit at LOW-POWER.
IL-6400: LOW-POWER -> FULL-POWER -> OFF. Boost is available when the lamp is switched on.
IL-6400 is equipped with a "Boost" function which is activated by holding the button down. IL-6400 will
provide over 50% more light in Boost mode compared to FULL-POWER, but it is intended to be used
only briefly to prevent overheating. The function stays on for as long the button is held down.
IL-640 EM SAFETY LIGHT
The light will be automatically turned on when the lamp is in the charging stand and the charging
power is cut off (power failure, etc.). IL-640 EM is always automatically in safety light mode when
placed in the charging stand.
Manufacturer: ATEXOR OY
P.O.Box 89, FIN-60101 SEINÄJOKI
Tel: +358-207 343 250
Internet: www.atexor.com
IL-640
IL-640 EM
IL-6400
User Manual
Advertisement
Table of Contents
Related Manuals for MICA IL-640
Summary of Contents for MICA IL-640
- Page 1 A pushbutton controls the functions of different lamp models as follows: IL-640: LOW-POWER -> FULL-POWER -> OFF IL-640 EM: LOW-POWER -> FULL-POWER -> OFF. If the lamp is in the charging stand and a power failure occurs, the lamp is automatically lit at LOW-POWER.
- Page 2 NiMH battery in an NiCd lamp! CHARGING AND STORAGE Do not charge IL-640 & IL-6400 lamps in charging stands other than the new MICA ILC4. Older MICA charging stands will not charge the lamp correctly, but can be upgraded to be suitable (contact your dealer for more information).
- Page 3 MICA IL-640 MICA IL-6400 IL-6400 lamp disassembly and assembly 1. Remove the charging contacts on the bottom of the lamp (open Phillips screws). 2. Open the six hex socket screws (2.5 mm hex key) and remove the lens frame, lens and seal.
- Page 4 Atexor service agent only. For maintenance repair, please send the lamp and the charger stand as well as the purchase receipt with the product. Note! A new MICA lamp/ battery must be used or recharged within three (3) months of manufacture.
Need help?
Do you have a question about the IL-640 and is the answer not in the manual?
Questions and answers