Hoover IRONjet User Manual page 6

Stand by
Temperature
Mark
Fabric
5
Chapter 1: Preparation for Use
Due to the powerful output of steam, Hoover recommends the use of an active
ironing board with blowing and vacuuming function which allows escape of any
excess steam.
Place the ironing system on a stable and level surface, for example on the hard part of
an ironing board or on a heat-resistant surface.
Chapter 1.1 : What Kind of Water May be Used?
The Hoover ironing system has been designed to be used with tap water only.
There is no need to use distilled or pure distilled water.
Nevertheless, in case you live in a hard water area, you can mix 50% of distilled water
with 50% of tap water.
Do not use any other kind of water or do not add any contents to water tank as it can
damage your appliance.
Chapter 1.2 : Filling the Water Tank
Filling With Water
Remove the mains plug from the wall socket before filling the iron.
Please fill your iron with normal tap water before using for the first time.
Set the steam button to the "0" position and open the water fill cover.
Use the water beaker attached to fill clean tap water into water tank until "MAX"
filling level.
Push the water fill cover firmly to close and dry any spilt water around the
enclosure of the appliance, do not overfill.
Warning: Do not add vinegar, hot water, perfume, or any other kind of chemical
agents or any other contents in the water tank. It could damage the steam
generator and shorten its life use.
Chapter 1.3 : Setting the Temperature
Stand the iron on its heel and plug the power cord into wall socket and the LCD
backlight will come on, indicating that the iron is receiving power.
Press on the iron set button until you get the desired temperature setting. We
recommend using the LCD panel display fabric as a guide.
When the LCD panel shows the text (fabric name) flashing and LCD panel of
the top of the temperature mark recycling by short to long, indicating that the
soleplate is heating up.
They will stop flashing when the iron reaches the selected temperature.
When the LCD panel shows the text (fabric name) flashing and LCD panel of
the top of the temperature mark recycling by long to short, indicating that the
soleplate is cooling down.
When iron in working status, push the set button and hold on for more than 3
seconds, then the iron will be in stand by status directly.