§1 Warranty MUTEC GmbH warrants the flawless performance of this product to the original buyer for a period of two (2) years from the date of purchase. If any failure occurs within the specified warranty period that is caused by defects in material and/or workmanship, MUTEC GmbH shall either repair or replace the product free of charge within 90 days.
MUTEC product through our website This all makes MC-4 for sure a unique and the most flexible digital audio immediately after purchasing. This ensures multichannel converter in a ½ 19“ case currently available in the market! full warranty services over a period of two years after purchasing the product.
Always be sure to connect the Word Clock output of the MC-4 rates. to the corresponding input of the device you wish to synchronize. Cable...
Page 12
T piece with its center connector into the input of the receiving device. Then, connect the cable coming from the MC-4’s Word Clock output to one of the lateral connectors, and the other connector of the BNC-T piece to a 75 Ω...
When setting up your MC-4 for the to the following three questions for the basic operation of your MC-4: first time, you will recognize that within the »REF CLOCK «...
SRC into AES3 and S/P-DIF, and 100.0kHz. the MC-4 needs to derive a valid clock signal from the incoming ADAT dio source. Therefore, the corresponding reference option is activated in the SMUX4 works equally to SMUX2. Due to the »REFERENCE«...
11.2896MHz + 12.288MHz, which are the x256 multiples of Running the MC-4 in the SRC mode, the clock rates of indivudual AES3 the Word Clock rates 44.1kHz and 48.0kHz. input signals can be totally different within a range of 25.0kHz to 200.0kHz.
IN 4 MODE AUDIO REFERENCE This setting is a special function of your MC-4! It allows to receive an Equal Clock Rates for AES3! ADAT signal with up to 50.0kHz sampling rate and an 8-channel AES3 signal between 25.0kHz and 200.0kHz simultaneously. The ADAT...
Individual AES3 Input Signals tion in these bidirectional conversion modes, Running the MC-4 in the SRC mode, the clock rates of indivudual AES3 due to the lack of simultaneous useable input signals can be totally different within a range of 25.0kHz to 200.0kHz.
SMUX2/4 signal at the same time, whereas both conversion streams may consist of different sampling rates. On this occasion, the MC-4 extracts the clock out of the two incoming digital audio signals and uses these clock references to synchronize the SRCs in front of each of the format-same outputs.
Bidirectional format and sampling rate conversion between SMUX4 and an 8-channel AES3 signal. The AES3 signals are all referenced to the fourth AES3 input signal. STATUS This area displays different system conditions of your MC-4. There is no access for changing settings. »LOCK «...
Page 22
\\\\\\\\\\\\\\\\\\ A N H A N G A N H A N G A N H A N G > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > The following basis reference clock rates are supported and analyzed: These indications are only available if Word Clock Rates...
\\\\\\\\\\\\ AP P E N D I X AP P E N D I X AP P E N D I X > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > Technical Data ADAT OPTICAL INPUT (8 CHANNELS)