Using The Microphone; Positioning The Microphone - Sennheiser evolution e 835 Instruction Manual

Using the microphone

Switching the e 835 S on/off
Use the on/off switch to switch the the e 835 S on or off.
X
If necessary, use the screw
X
"on" position.

Positioning the microphone

Pos. Resulting sound
C.1 • High proximity effect
(large bass boost)
• Powerful, direct sound
C.2 • Less proximity effect
(less bass boost)
• Some room ambience,
natural, balanced sound
C.3 • Very little proximity effect
(minimal bass boost)
• More room ambience,
indirect sound
If sibilance occurs:
Position the microphone slightly to the side and not directly in front
X
of the mouth.
Positioning the monitor loudspeakers
To prevent feedback and crosstalk, postion your monitor loudspeak-
X
ers in the angle area of the highest cancellation of the microphone
(approx. 180°).
Cleaning and maintaining the e 835
Caution
Unscrew the sound inlet basket
X
Remove the foam insert from the sound inlet basket
X
Use a slightly damp cloth to clean the sound inlet basket
X
the inside and ouside.
Reinsert the foam insert into the sound inlet basket
X
the sound inlet basket on the microphone and screw it tight.
Liquids can damage the electronics of the product!
Liquids entering the housing of the product can cause
a short-circuit and damage the electronics.
Keep all liquids away from the product.
X
Do not use any solvents or cleansing agents.
X
4 to lock the on/off switch
C
1 .
3
Commentary
Very little crosstalk
from other sound
sources
More crosstalk from
other sound sources
Higher crosstalk from
other sound sources
B
1 .
1 and replace
in the
from
1
3