Working Instructions - Fein KS10-38E Instruction Manual

OBJ_BUCH-0000000046-001.book Page 16 Monday, August 1, 2011 1:33 PM
en
16

Working instructions.

Before mounting or replacing application tools or accessories, pull the power
WARNING
plug. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Adjusting the Speed (figure 7).
The speed range can be variably adjusted, as
shown in the following figure.
Set the dial control between "1" for the low-
est speed range and "6" for the highest speed
range.
Switching on and off (figure 8).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The self-start lock prevents the power tool
from automatically restarting again, even after
a brief interruption of the power supply, e. g.,
from a pulled mains plug.
Switching on:
Push the switch toward the front (I).
Switching off:
Press the switch downward ().