Internal Speaker Selector; Radio Channel - Foxpro Scorpion X1A Instruction Manual

Configuring Play Modes:
1. Make sure that the Scorpion is turned off.
2. Unlock the two latches on the front and lift up the lid to fully open the Scorpion.
3. Locate the mode selection configuration pins inside the Scorpion. Refer to the image
above to set the configuration. Pins 2 and 3 set the configuration for the factory
default repeat mode. Pins 3 and 4 set the configuration for jukebox mode.
4. Close the lid and proceed with operation.

5-3 Internal Speaker Selector

Please refer to Section 4-1 for more information on configuring the internal speaker.

5-4 Radio Channel

The default radio channel for the Scorpion is "B." Channel "C" is also available for operation of
the Scorpion if both the Scorpion and TX200 transmitter are configured to that channel.
Changing the Radio Channel:
1. Make sure that the Scorpion is turned off.
2. Unlock the two latches on the front and lift up the lid to fully open the Scorpion.
3. Locate the channel selection configuration pins. Refer to the image above to set the
configuration. Pins 1 and 2 set operation for channel "B" and pins 2 and 3 set
operation for channel "C".
4. Turn on the TX200 transmitter.
5. Simultaneously depress the P3 and P4 buttons. This allows you to toggle between
radio channels "A", "B", and "C". The TX200 will not operate the Scorpion on channel
"A".
14