Wings - AJ Aircraft Laser 230z Assembly Instructions Manual

61) Assemble the control horns and ball-link the same as you did the elevators. Cut the slots in the bottom of each ailerons, test fit
the control horns, mark around the baseplate and cut away the covering. Glue in the horns exactly as you've done previously.
62) Utilizing a fresh blade, carefully cut and remove the covering exposing the servo mount located on the underside of each wing
panel. Apply some thin CA to all accessible joints of the servo mount and ribs.
63) Attach 6 inch servo extensions onto the servo leads and secure with heat shrink or string. Using the string inside the wing, tape
the extension to the string and pull the extension through the wing.
Section 3 — Wings