Troubleshooting - jablotron tiny CMD 6129S Manual

TROUBLESHOOTING

If any difficulties with the video monitor occur, please see the possible solutions below:
Symptoms Solution
1. Check the AC adaptor of the camera – whether it is connected
to the camera and plugged into the mains.
2. Make sure that the camera and receiver are both ON.
No picture from a camera
3. Make sure that the camera is in range of the receiver.
4. If using the accumulator, check the capacity or replace the batteries
if needed.
1. The signal from the camera may be too low. Move the camera closer
The picture is dropping out to the receiver.
2. Try repositioning the camera, receiver or both to improve the reception.
1. Ensure that the volume on the receiver is turned up.
2. Make sure that there is no disturbing sound within range of the
Audio problems camera microphone.
3. If the unit emits a loud screeching noise (feedback), move the came-
ra or receiver farther apart.
The picture may become choppy when experiencing a lower
The picture has become frame rate (refreshing less than 10 times a second).
choppy Try moving
obstructions between the receiver and camera.
The picture might be grainy as the camera video resolution is set to
The picture appears to be
VGA (640x480 pixels). This is not a product defect.
grainy when using the AV
1. For best performance use the PIP (Picture in Picture)
output for viewing on a
function on the TV.
large screen
2. Check if the video resolution is set to the "high" option.
TECHNICAL SPECIFICATION – RECEIVER
Receiver Frequency Range 2.400 GHz~2.482 GHz
Data Rate 1.5 Mbps
Receiving Sensitivity -81 dBm
Demodulation Type GFSK with FHSS
Resolution H: 480 V: 240
Viewing Angle H: 50° V: 50°
A/V Output / Resolution VGA 640x320 / 15FPS, QVGA 320x240 / 30 fps
Alert volume 80 dB ±10 % / 1 m
Power Requirement 9 V DC ±5%
Power Consumption 400mA max without charging, 800mA with charging
Battery operation up to 3 hours (according the condition)
Battery parameters LiPO 7.4 V / 950 mAh (MLP 563450)
Operating Temp Range 14°F ~ 140°F / -10°C ~ +60°C
Max. Operating Humidity 85% RH
26
MZZ56200
EN
the camera closer to the receiver.
TECHNICAL SPECIFICATION – CAMERA
Transmit Frequency Range
Can be operated according to
Data Rate
Transmitting Power
Modulation Type
Communication Range
Image Sensor Type
Effective Pixels
Image Processing
Image Resolution / Frame Rate
White Balance
Audio parameters
Lens
Viewing Angle (Diagonal)
Minimum Illumination
Remove
IR LED / Night Vision Range
Power Requirement
Power Consumption
Battery operation
Battery parameters
Operating Temperature
Max. Operating Humidity
Environmental Rating
Dimensions / (W x D x H)
1177
FCC ID Sj8CA610
SERVICE PROVIDED BY:
Jablotron alarMs a.s.
Pod skalkou 4567/33
466 01 Jablonec nad nisou
czech republic
tel: +420 483 559 956
e-mail: nanny@jablotron.cz
web: www.jablotron.com
EN
2.400 GHz~2.482 GHz
ERC REC 70-03
1.5 Mbps
14 dBm (TYP)
GFSK with FHSS
150 m (Line of Sight)
1/4" Color CMOS Image Sensor
H: 640 V: 480
Motion jPEG
H: 640 V: 480 / 30FPS Max.
Yes
AEG 0 dB ~ 24 dB
4.9 mm / F2.8
60°
2.5 LUX (IR off), 0 LUX (IR on)
8 LEDs / 840nm 5m (with IR LED)
9V DC ±5%
360mA MAX (w/ Night Light) / 300mA (without Night Light)
up to 3 hours (according the condition)
NiMH 6 V / 750 mAh (BP 610)
14°F ~ 104°F (-10°C ~ +40°C)
85 %
14°F ~ 140°F (-10°C ~ +60°C)
2.6" x 5.7" x 3.3" / 66mm x 145mm x 84mm
Jablotron alarMs a.s. hereby declares that the cMd 6129s tiny
is in compliance with the essential requirements and other relevant
provisions of directive 1999/5/ec and complies with part 15 of the
FCC rules. Operation is subject to the following two conditions: 1. This
device may not cause harmful interference, and 2. this device must
accept any interference received, including interference that may cause
undesired operation.
Caution: Changes or modifications not expressly approved by Jablotron
could void the user´s authority to operate the equipment. the original of the
conformity assessment can be found on the web site www.jablotron.com.
Note: although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the producer after use.
27
MZZ56200