Table of Contents
Advertisement
ADjUSTING THE RECEIVER VOLUME
the receiver volume can be adjusted by using the
uP/doWn arrows
u v
while watching the video.
Press the doWn arrow
v
to decrease the volume
and the uP arrow
u
to increase the volume. When
the volume is set to one bar (lowest setting), the
volume is muted.
the volume strength indicator is shown on
display while the volume is being adjusted and will
disappear 10 seconds after final setting.
ACCESSING MENU OPTIONS OF THE RECEIVER
Press the Menu button on the receiver to enter the menu options. use the navigating arrows to move
up/down/left/right in the menu, and press the OK button to confirm a selection.
Main Menu
the Main Menu contains 4 submenus:
1. PAIRING – For adding more cameras to the receiver.
NOTE: This option is not available for the Tiny monitor.
2. EV – adjusts the exposure level of the camera.
3. POWER SAVING – turns on the receiver
power save mode (when no activity on the camera is
detected, the lcd screen on receiver will switch off).
4. SETTING – sets the aV output options and
resets the receiver to factory defaults (erases all
configurations).
Pairing Submenu
Function not available for Tiny monitor. the system
comes with a single camera that has already been
paired. When you switch on the receiver and the
camera, you are able to see the video immediately.
24
MZZ56200
EN
EV Menu
the eV Menu is used to adjust the exposure of the camera.
use the leFt
and right
s
arrows to change the bar from darkest (left) to lightest (right). Press the
ok button to accept the setting.
Power Saving Submenu
the Power saving Menu is used to turn off the lcd
screen at a preset time to save the battery. this
function can be set from 1 minute to up to 10 minutes.
the cancel option switches this feature off.
When the Power saving option is on, the lcd screen
would only be switched on by activation by the preset
volume level or by pushing any button on the front
of the receiver.
When the lcd screen is activated by button
pushing, it will turn back to Power saving mode
after the preset time expires. if it is activated by
sound in the monitored area, it will go back to
a black screen after 5 seconds.
Setting Submenu
The Setting Menu contains 2 submenus:
1. A/V Out – changes the quality of the image sent
to the a/V receiving device (i.e. tV or monitor).
2. Default – resets all menu settings to the factory
defaults.
A/V Out Menu
the a/V out menu option is used to adjust the
resolution quality of the image for tV, monitor etc.
use the uP
u
and doWn
v
arrows to select a
resolution, and press ok to accept your option.
NOTE: It is strongly recommended to use the "High"
resolution to ensure the best image resolution
on a large screen (default setting).
Default Menu
the default option is used to reset the receiver to
factory settings – all menu settings will be reset.
use the uP
u
and doWn
v
arrows to select Yes,
and press ok to accept.
NOTE: camera pairing will not be affected by a
reset.
EN
MZZ56200
25
Advertisement
Table of Contents
