Need Help - Hoover HSV-AC2IN1 Instruction Manual

Need Help?

What to do if it goes wrong
Problem Solution
y Check the battery is inserted correctly into
the vacuum cleaner. Go to "Getting started
with your LithiumLife or LithiumLife Extended
Runtime battery".
y Check the handheld has been correctly fitted
into the main body. Go to "Using your Air
Why does my
Cordless Hand Vac".
vacuum cleaner
have no power? y The battery may not be charged, remove and
charge battery.
y Check terminals on battery and vacuum
cleaner are clean. Go to "Keep Your Air
Cordless Hand Vac Running Properly:
Motorized Turbo Tool & Battery".
y Battery might be too hot, remove and allow to
cool for 30 minutes.Replace battery.
y The Motor Protection Sensor may have been
activated. If this has happened,switch off the
vacuum cleaner. Remove and empty the dirt
container and check for blockages. Clean the
filters and allow the vacuum cleaner to cool
for approximately 1 hour (if you have washed
11
To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/troubleshooting checks.
Why won't the
vacuum cleaner
pick up?
My brushbar
isn't turning?
WARNING
! !
the filters you will need to wait 24 hours for the
filters to fully dry before putting them back into
the vacuum cleaner).
y Empty the dirt container and clean filters. Go
to "Keep your Air Cordless 2-in-1 running
properly: Filter & Dirt cup ".
y There may be a blockage in the vacuum
cleaner. Check the brushbar, the nozzle of
handheld, separator, shroud and tool for
blockages.
y The separator has not been fitted correctly.
Go to "Keep Your Air Cordless Hand Vac
Running Properly: Dirt Cup".
y The brushbar may not be turning. Go to
"Keep Your Air Cordless Hand Vac Running
Properly: Brush Roll" below.
y The brushbar may not be switched on. Check
the on/off control brush bar roll has been
turned to carpet mode. Go to "Using your Air
Cordless 2-in-1".
y The brushbar may be obstructed. Go to
"Keep Your Air Cordless Hand Vac Running
Properly: Brush Roll".