Table of Contents
Advertisement
Chapter 6
LAYER Mode
To change to a different secondary sound, the Voice button's LED must be lit. Choose the category you
want on Row 1 or Row 2 by pressing the Voice button to switch rows. Select the category of sound you
desire. Advance with the Prev- or +Next buttons to find your desired sound.
The new sound chosen is now your secondary sound. Remaining in Layer Mode, only the secondary
sound can be changed. You must start over to change your primary sound and create your desired
combination.
To exit Layer Mode, press the Layer button again.
Volume Balance
This parameter sets the balance volume between the 2 layered sounds.
Press the Layer button to enter Layer Mode. Press the Select▲ button to set the volume between
the layered voices. The display reads VOL:0 (the default setting) or the last setting selected since the
instrument was switched on.
Use the Prev- button to decrease the volume of the secondary
voice. The range is from 0 to -9. Press the +Next button to
increase the volume of the secondary voice. The range is from 0 to
+9. This will allow you to customize the balance between your two
voices.
Layer Octave Transposition
This parameter sets the transposition of the secondary voice relative to the primary voice.
In Layer Mode, press the Select▲ button until the screen displays:
XPOSE:0.
To transpose the secondary voice up an octave, press the +Next
button once. The screen will display 12. Press the +Next button
twice to move up 2 octaves. The screen will display 24. To lower an
octave, simply reverse the steps by pressing Prev- button to change or
lower the octaves for the secondary voice. The default setting is 0, or the last setting selected since the
instrument was switched on.
Saving Layered Voices
Using Favorite Buttons
Once you have created your layered sound, select a Favorite button 1-6 to store the layered voice.
Press and hold any Favorite button. The layered voice is now stored in that location.
To Exit Layer Mode, press the Layer button again.
page 16
If you have already saved a layered voice as a Favorite and want to make a change, select the Favorite first,
then press the Layer button to enter Layer Mode.
VOL : 0
XPOSE: 0
Using the Save Button
Once you have created your layered sound, press the Save button located to the left of the screen. The
first empty location in the Favorites will be displayed. The display reads: Save Voice As.. F(# of empty
location). Press the +Next button to choose a different location. Press the Save button again to save
the layered voice.
If all Favorite locations have been used, pressing the Prev- or
+Next buttons will step through all six locations, allowing you to
choose one to overwrite.
Chapter 6
Layer Mode
page 17
Advertisement
Table of Contents
