Subscribe to Our Youtube Channel
Related Manuals for DriSteem 201
Summary of Contents for DriSteem 201
- Page 1 READ AND SAVE THESE INSTRUCTIONS WATER TREATMENT 200 ser ies r eve rse -o smo sis s ys t em s Installation, Operation, and Maintenance Manual...
- Page 2 WARNINGS AND CAUTIONS DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL ..
-
Page 3: Warnings And Cautions
Follow all instructions in this manual to maintain product warranty. FILL IN THE FOLLOWING INFORMATION FOR YOUR RECORDS Date of purchase ___________________________________________________________________________________________________________ Customer's name ___________________________________________________________________________________________________________ Model number ___________________________________________________________________________________________________________ Serial number ___________________________________________________________________________________________________________ DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 4: Table Of Contents
Shutdown ......... . . 10 DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 5: Attention Installer
WARRANTY ............Download DriSteem literature Most DriSteem product manuals are available our website: www.dristeem.com DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 6: Overview
°F (°C) 10/50 10/50 10/50 Pre-fi lters Sediment cartridge - 5 micron Carbon cartridge - 10 micron Pressure switch settings Low pressure (for pump protection) 8 psi 8 psi 8 psi DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 7: Flow Schematic
OVERVIEW Flow schematic FIGURE 3-1: FLOW SCHEMATIC OM-7822 DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 8: Component Identification
To adjust and maintain adequate fl ow thru membranes Monitors the feed and permeate water quality. TDS monitor 12a - feed sensor; 12b - permeate sensor Permeate check valve Prevents backfl ow into RO module. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 9: System Installation
fl ow back through this line. FIGURE 5-2: RECIRC FLOW LINE CAUTION Confi rm all lines are connected before plugging in unit power. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 10: Pre-Treatment Connection
Tank full restart time delay (two seconds) Switch 5 and 6 not used. Input contact type (NC, open to operate) If you desire to change any switch functions, move that switch to the ON position. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. - Page 11 INSTALLATION Schematic drawing FIGURE 7-1: CONTROLLER ELECTRICAL SCHEMATIC OM-7821 DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL...
-
Page 12: Ro Pump Wiring
NOTE: The output from the pretreatment device must be a dry contact and must not supply voltage. TANK FULL SWITCH DriSteem systems use a pressure switch to keep the pressurized storage tank between 30-50 psi (207-345 kPa). The switch is connected to the tank full input. -
Page 13: Operation
If switch one and two are in the ON position after a pressure fault condition, the RO unit will continually attempt to restart after each 60 minute cycle, until the pressure switch input has cleared. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 14: System Operation Continued
30 seconds, press the power button OFF, and close the concentrate valve. This will hold the preservative in the pressure vessel. 3. When the system is restarted after an extended shutdown, follow initial system start-up procedures. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 15: Maintenance
• Clean and preserve membranes without removing them from your system • Reduce downtime • Maintain your system performance at a higher level • Prolong membrane life by regular use of cleaning cartridge DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 16: Membrane Cleaning In The Ro System
7. Remove the empty cleaning cartridge and replace it with the original filter. 8. Restart the system. Direct the permeate to drain for five minutes. 9. Go back to normal operations. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 17: Organic Cleaning Cartridge
7. Remove the empty cleaning cartridge and replace it with the original filter. 8. Restart the system. Direct the permeate to drain for five minutes. 9. Go back to normal operations. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 18: Membrane Preservative Cartridge
9. Remove the empty preservative cartridge and replace it with a new cartridge filter. 10. Restart the system. Direct permeate to drain for 15-30 minutes. 11. Go back to normal operation. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 19: Tools
4. Remove u-pins from the vessel. Slowly and carefully pull the end plugs out from the fitting with a channel lock. 5. Remove end plugs by pulling carefully. DriSteem replacement part number 550035-025. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... -
Page 20: Procedure
6. Rotate the housing clockwise until hand tight. 1. Carbon filter: Primarily to remove chlorine; also removes organics and sediments down to 10 microns. 2. Sediment filter: Removes sediments and particles down to 5 micron size. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL .. -
Page 21: Tools
1. Permit chlorine in the feed water. 2. Shut down the system for extended periods without preserving the membranes. 3. Close the concentrate control valve completely. 4. Operate the system with insufficient feed flow. DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL... - Page 22 Permeate quality poor Low inlet fl ow Adjust concentrate control valve Low system pressure See "Inlet pressure low" Recovery too high Reduce recovery Membranes fouled Clean membranes Membranes damaged Replace membranes DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL ..
- Page 23 Cartridge in psi Cartridge out psi Water temperature TDS in TDS out System psi Concentrate psi Cartrdige fi lter change Membrane change Recorded by Notes _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ _________________________________________________________________________________________________________________________________ DRISTEEM WATER TREATMENT SYSTEMS INSTALLATION, OPERATION, AND MAINTENANCE MANUAL...
-
Page 24: Warranty
DriSteem’s Limited Warranty shall not be effective or actionable unless there is compliance with all installation and operating instructions furnished by DriSteem, or if the products have been modifi ed or altered without the written consent of DriSteem, or if such products have been subject For more information to accident, misuse, mishandling, tampering, negligence or improper maintenance.
Need help?
Do you have a question about the 201 and is the answer not in the manual?
Questions and answers