Replacing Battery; Calibration - Fakir DIGICUP Instruction Manual

GB
Tare (set zero) Function
Reversing the Tare Function

Replacing Battery

Calibration

To calibrate
11
USING THE APPLIANCE GENEL BAKIfi
Yo¤unluk
Water 1 kg/L
Milk 1.03 kg/L
0.9 kg/L
Oil
0.84 kg/L
Sugar
0.6 kg/L
Flour
It is easy and convenient to build up & mix different ingredients
together all in the same cup with DigiCup kitchen scale. After
the first ingredient is added and measured, press (Ø) button
to reset the reading zero and you may add another ingredient
after performing the tare function below.
NOTICE!
The tare function only operate when the cup is placed
on a flat surface
Right after the tare function has been performed and the
display is showing "0" reading with the "TARE" icon appeared,
you can press (Ø) button to resume the original weight or
volume reading just before the tare function.
NOTICE!
The reverse tare function only operate when the cup is
placed on a flat surface
Slide down the battery door to open. Replace 1 piece of
CR2450 battery according to the polarity indicated and close
the battery door.
To ensure accurate measurement, you are suggested to check
the weight of an empty cup, it should read 0. If it shows another
number, it surely requires calibration.
1)Make sure the transparent cup is attached to the base.
2)Make sure the cup is empty and clean.
3)Turn on the unit by a single press of the (Ø) button.
4)Make sure the cup is placed steadily on a flat surface. Hold
(Ø) for 6 seconds until "CAL" flashes. Do not touch or move
the cup when "CAL" is flashing.
The display reading will show "0" and the calibration is
completed.
Birimler
mL, CUPS, FL OZ
mL, CUPS, FL OZ
mL, CUPS, FL OZ
GRAMS, CUPS, LBS OZ
GRAMS, CUPS, LBS OZ