Power On/Off
Button
"Ø" zero
M (mode)
U (unit)
Weight-Volume
Measurement
USING THE APPLIANCE
This appliance includes 1 pcs lithium battery (CR2450). Before
using, take off the isolation band from the battery.
Make sure the cup is attached to the base.
Place the cup scale on a flat surface and press the (Ø) button
to turn on the unit. It should read 0 for your empty cup. If not,
please calibrate the cup following the instruction in the
"CALIBRATION" section.
Hold (Ø) button for 3 seconds to turn off the unit.
The unit turns off automatically after 5 minutes in idle state.
Press Functions
Turn on the unit
Tare or reserve tare
Change the display
mode
Select display unit
DigiCup kitchen scale is built in the measuring cup and it can
measure both the weight and the volume of your food and
revert weight to volume of your selected ingredients ; water,
milk, oil, sugar or flour.
Weight Measurement
1)Select "SCALE" display mode by pressing [M] button
repeatedly until the arrow icon is pointing to "Scale"
2)Press [U] to choose desired weight unit.
3)Place the ingredient into the cup which is on the flat surface.
4)Place the cup on a flat table to display the reading.
Volume Measurement
1)Select the ingredient between water, milk, oil, sugar or flour
by pressing [M] button repeatedly
2)Press [U] to change to the desired unit.
3) Place the ingredient into the cup which is on the flat surface.
4)Place the cup on a flat table to display the reading.
There are different types of milk, oil, sugar or flour in the
market. Different types, brands & origins of the same
ingredient have different density. For this reason, some
variation on the volume measurement will occur
depending on the type of ingredients you are using.
The volume reading provided by the cup can only be
used as an approximate value. The density and type of
ingredients being used in the cup are shown below.
Hold 3 seconds
Turn off the unit
NOT!
GB
Hold 6 seconds
When the unit is on
hold 6 sec.
10
Need help?
Do you have a question about the DIGICUP and is the answer not in the manual?