Section 5 − Installation; Installing Welding Generator - Miller Electric 145 DXR, 145 Owner's Manual

5-1. Installing Welding Generator

Movement
Location
Always securely fasten welding
generator onto transport vehicle
or trailer and comply with all
DOT and other applicable codes
OM-4417 Page 16
SECTION 5 − INSTALLATION
OR
2
3
GND/PE
.
Complete Parts List available at www.MillerWelds.com
Airflow Clearance
18 in
(460 mm)
18 in
(460 mm)
18 in
(460 mm)
1
18 in
(460 mm)
18 in
(460 mm)
Do not install unit where air
flow is restricted or engine
may overheat.
Always ground generator frame
to vehicle frame to prevent elec-
tric shock and static electricity
hazards.
1 Metal Vehicle Frame
2 Equipment Grounding
Terminal
3 Grounding Cable
Bed liners, shipping skids, and
some running gear insulate the
welding generator from the ve-
hicle frame. Always connect a
ground wire from the generator
equipment grounding terminal
to bare metal on the vehicle
frame as shown.
Use #10 AWG or larger insulated
copper wire to make metal-to-met-
al grounding connection.
If unit does not have GFCI
receptacles, use GFCI-
protected extension cord.
Ref 151 556 / Ref. 800 652 / 803 597-B / S-0854