Electrical Connection - Proaction A105QW Installation & User's Instructions

Installation
Electrical connections
Any electrical work that is
required to install this washing
machine MUST be carried out
by a qualified electrician.
Warning: THIS APPLIANCE
MUST BE EARTHED
Before making any electrical connections,
ensure that:
•
Ensure the power socket is suitable for the
maximum power of the washing machine
(fuses in the power circuit must be 13 amp).
•
The supply voltage should be the same as
that indicated in the technical specifications
(page 17) and the appliance rating plate
(located where shown).
•
The appliance should be earthed and in
compliance with the applicable law.
•
Additional earth cables should not be
necessary if the plug and socket are earthed.
If necessary, an additional earth cable
should be attached to the earth terminal on
the back of the washing machine and
earthed.
•
When installed, the power socket must be
within easy reach.
•
The use of adapters, multiple connectors or
extension cables are not recommended.
•
The appliance must be connected to a 220-
240 volt 50 cycle AC supply by means of a
three pin socket, suitably earthed and
protected by a 13 amp fuse.
•
Should the fuse need to be replaced, a 13
amp fuse approved to BS1363/A must be
used.
•
The plug contains a removable fuse cover
that must be refitted when the fuse is
replaced. If the fuse cover is lost or
damaged, the plug must not be used until a
replacement cover has been fitted or the
plug is replaced.
•
A damaged plug should be cut off as close
to the plug body as possible, the fuse should
be removed and the plug disposed of safely.
Customer Helpline: 0845 600 4632
Plug replacement (UK & Ireland only)
Should you need to replace the plug; the wires
in the power cable are coloured in the following
way:
Blue – Neutral 'N'
Brown – Live 'L'
Green & Yellow – Earth 'E'
As the colours of the wires in the power cable
may not correspond with the coloured markings
identifying the terminals in your plug, and
proceed as follows:
The green & yellow wire must be connected to
the terminal in the plug that is marked with the
letter E or by the earth symbol.
The blue wire must be connected to the terminal
that is marked with the letter N.
The brown wire must be connected to the
terminal that is marked with the letter L.
If the power lead is damaged, it must be
replaced by a qualified electrician.
6