Error Signals - Proaction A105QW Installation & User's Instructions

Error Signals

Your machine is equipped with systems which will take the necessary precautions and warn you in
case of any. IMPORTANT: IT CAN TAKE UPTO 10 MINUTES FOR ERROR TO REGISTER.
FAILURE
CODE
Err 01
Err 02
Err 03
Err 05
Err 06
Err 07
Err 08
Err 09
(*) See the section regarding the care and maintenance of your machine.
FAILURE
INDICATOR
The start/pause The door is not
light blinks. shut properly.
The water level in
your machine is
below heater. The
The program pressure of your
ready light blinks. water supply may
be low or water
supply may be
blocked.
The pump has
The start/pause
failed or the
light and program
pump filter is
ready light blinks .
obstructed.
The heater of
The start/pause
your machine or
light and program
the heat sensor
end light blink.
has failed.
The program
ready light and The motor has
program end light failed.
blink.
The start/pause
light, program
Electronic
ready light and
configuration
program end light
error.
stays on
permanently.
The start/pause
light, program
The motor has
ready light and
failed.
program end light
blink.
The program
ready and The network
program end voltage is too
lights stay on high or too low.
permanently.
Customer Helpline: 0845 600 4632
PROBABLE
PROCESS TO BE FOLLOWED
FAILURE
Shut the door properly so that
you hear the click. If the
problem persists, turn off the
machine unplug and contact the
nearest authorised service agent
immediately.
Turn on the tap fully. The water
supply may be interrupted. If the
problem persists, your machine
will automatically stop after a
while.Unplug your machine, turn
off the tap and contact the
nearest authorised service agent
immediately.
Clean the pump filter.If the
problem persists and contact
the nearest authorised service
agent immediately. (*)
Shut down your machine and
unplug. Turn off your tap and
contact the nearest authorised
service agent immediately.
Shut down your machine and
unplug. Turn off the tap and
contact the nearest authorised
service agent immediately.
Shut down your machine and
unplug. Turn off the tap and
contact the nearest authorised
service agent immediately.
Shut down your machine and
unplug. Turn off the tap and
contact the nearest authorised
service agent immediately.
If the network voltage is lower
than 150V or higher than 260V,
your machine will automatically
stop. When the network voltage
is recovered, your machine will
continue its operation.
12