Proaction A105QW Installation & User's Instructions page 17

Trouble Shooting
FAILURE
Excessive foam in
the detergent drawer.
The washing result is
poor.
The washing result is
not good.
The water is drained
from the machine as
soon as it is filled.
No water is seen in
the drum during
washing.
There are residues of
detergent on the
clothes.
There are grey stains
on the clothes.
The spinning process
is not done or starts
with delay .
(*) See the section concerning the care and maintenance of your machine.
(**) See the section concerning installation of your machine.
PROBABLE CAUSE
Too much detergent has been
used.
Wrong detergent has been used.
Your laundry is too dirty for the
programme you have selected.
The amount of detergent used is
not sufficient.
Clothes exceeding the maximum
capacity have been loaded in the
machine.
Your water may be hard.
Distribution of the clothes in your
machine is not well-balanced.
The end of the water drain hose is
in a position too low according to
the machine.
No failure. The water is in the
lower part of the drum.
Some detergents contain
ingredients which are not soluble
in water and which may form
white stains on your clothes.
These stains may be caused by
oil,cream or ointment .
No failure. The unbalanced load
control may work in that way.
Customer Helpline: 0845 600 4632
METHODS OF ELIMINATION
Press the start/pause button.In order to
stop the foam,dilute one table-spoon of
softener in half liter of water and pour it
in the detergent drawer.Press the
start/pause button after 5-10
minutes.Arrange the amount of the
detergent properly in the next washing
process.
Use only the detergents produced for
full automatic machines.
Select a suitable programme.
page 8)
Use more detergent.
Put the clothes in your machine in a
manner not to exceed its maximum
capacity.
Use the amount of detergent specified
by the detergent manufacturer.
Spread the clothes inside the machine in
an orderly and well-balanced manner .
Position the water drain at an
appropriate height.(**)
-
By adjusting your machine, carry out an
additional rinse, or eliminate the stains
after drying, with a brush.
In the next washing operation, use the
maximum detergent amount declared by
the detergent producer.
The unbalanced load control system will
try to distribute your clothes in a
homogenous manner. After your clothes
are distributed, passage to spining
process will be realized. In the next
washing process,place your clothes into
the machine in a well-balanced manner.
(see
16