Installation And Service Checklist - Boyertown Furnace RSM 500 Installation, Operation And Maintenance Manual

Furnace Model: _______________________
Installation Date: ______________________
Installer Name: ________________________
Furnace Installation
□
Furnace level and in solid contact with floor?
□
Furnace and burner wired per wiring diagram and National Electric Code? 120VAC wiring Type_____ Size _____
AWG
□
Burner sealed to furnace? Mounting nuts tight?
□
Space is large enough to provide required clearances?
□
NFPA 31 Installation of Oil Burning Equipment followed?
□
Local, state and national codes, laws, regulations and ordinances followed?
Vent System
□
Existing chimney and vent system inspected to NFPA 211 and in good condition?
□
New vent pipe installed and properly sealed?
□
Vent size checked against furnace manual and codes?
Duct Work
□
Return and supply ducts checked for size based on furnace air flow and ACCA Manual D?
□
All ducts sealed and insulated as required?
Burner Operation
□
Burner Model: __________________ Nozzle: _______GPH _______Deg. _______Type_______
□
Burner Pump Pressure: ______________
□
Fuel filter and fuel lines installed and inspected as per burner manual?
□
Air bled from oil piping? Piping checked for leaks?
□
Burner started, adjusted and tested per burner manual?
Furnace Operation
□
Thermostat heat anticipator set per burner manual instructions?
□
Temperature rise through the furnace checked 60
□
Blower motor amperage does not exceed rated full load amperage?
□
Clean air filter installed?
□
Limit control tested for proper operation?
□
Furnace observed going through several operational cycles for proper operation?
Post Installation
□
Reviewed owners' information in this manual with owner or maintenance personnel and instructed to keep for future
reference?
□
Properly filled in and returned warranty registration card to Boyertown Furnace Co.
Installation and Service Check List
Inserted burner manual instructions with furnace manual for future use?
Serial No.: ______________________
Phone No.: ______________________
0
F maximum and blower speed adjusted as required?
35