Aligning The Doors - Haier HRF24E3APS Installation And User Manual

5. Turn the top hinge fastener counterclockwise and remove the
top hinge.
6. Lift up the door and remove it.
REMOVE RIGHT-HAND DOOR
1. Turn the top hinge fastener counterclockwise and remove the
top hinge.
2. Lift up the door and remove it.
REMOVE THE FREEZER DRAWER FRONT
1. Slide open the freezer drawer as far as possible. Remove the
freezer drawer by releasing the tabs on both sides with a small
screwdriver, and then lift up.
2. Remove the freezer bin by lifting up and out at an angle.
3. Remove the screws (one on each side) that secure the freezer
drawer front brackets to the sliding rail assemblies.
a
a
4. Hold the drawer front with both hands, and lift up to release the
hooks on the freezer drawer front brackets from the sliding rail
assembly. Set the drawer front aside.
5. Push the sliding rail assembly back into each side of the freezer.
REPLACE REFRIGERATOR DOORS
1. Place the door onto the bottom hinge pin.
NOTE: Provide additional support for the door while the hinges
are being moved. Do not depend on the door gasket magnets to
hold the door in place while you are working.
2. Left-hand door only, reconnect the wire harness, water tubing
and the ground wire.
3. Insert and install the top hinge into the door and the refrigerator
cabinet. Do not tighten screws completely.
Screw
4. Adjust the door so that the bottom of the refrigerator door
aligns with the top of the freezer drawer. Tighten all screws.

ALIGNING THE DOORS

If the refrigerator doors are not properly aligned:
1. Unscrew the top hinge cover and tilt it backward to access the
hinge. Do not disconnect any harness wire or water tube.
2. Loosen the fastener counterclockwise, move the hinge
sideways to adjust the refrigerator door. Do not remove the
fastener.
3. Tighten the fastener and replace the top hinge cover.
REPLACE FREEZER DRAWER FRONT
1. Extend the sliding rail assembly out as far as possible from each
side of the freezer.
2. Using both hands, hold the drawer front at an angle and insert
the hooks on the drawer front brackets into the sliding rail
assemblies.
a
a
Hook
5