Miele T 8947 WP Operating Instructions Manual page 44

Problem solving guide
Problem
There are humming
noises.
The display is dark.
The programme
selector is not lit up.
The Start/Stop button
light flashes slowly.
A programme cannot
be started.
Power cut
The display is in a
different language.
The Start/Stop button
light flashes when a
programme is being
selected.
The interior drum
lighting does not
come on.
44
Possible cause
The compressor is
operating.
The display has
switched off
automatically to save
energy (Standby mode).
The light of the
programme selector
goes out when selecting
Menu J.
There is no immediate
cause.
When power is restored to the dryer after a power cut,
the programme will continue as long as the cooling
down phase had not been reached.
A different language has
been selected.
This is not a fault.
The flashing indicates
that a programme can
be started.
The lighting switches off
automatically (to save
energy).
Remedy
None. These noises are quite
normal and do not indicate a
fault.
The display will light up
when one of the buttons is
pressed.
– Is the dryer switched on?
– Is the mains plug plugged
in?
– Is the door closed
properly?
– Has the fuse or circuit
breaker tripped?
Set the language you want.
The flag symbol J will guide
you.
After the programme has
started, the flashing will
change to a constant light.
– Switch the dryer off and
then on again.
– If the lamp needs to be
replaced, follow the
instructions in "Changing
the lamp" at the end of this
section.