Comfort Adjustments - Pride Mobility legend xl Owner's Manual

V I I I .
SEATBACK ADJUSTMENT
WARNING!
scooter with the seatback in a
reclined position.
WARNING! Always keep your back
pressed firmly against the seatback
while adjusting the angle.
To adjust your scooter's reclining seat, perform these
steps. See figure 12A.
1. With your back pressed up against the seatback,
lift up on the seatback adjustment lever and lean
forward or rearward to adjust the seatback angle.
2. Release the seatback adjustment lever once the
seat is in a comfortable riding position.
ARMREST ANGLE ADJUSTMENT
The armrest angle of your scooter can be adjusted up-
ward or downward by turning the adjustment dial. See
figure 12B.
NOTE: Pivot the armrests upward to make get-
ting onto and off of your scooter easier.
SEAT HEIGHT ADJUSTMENT
You can change the seat height to one of three positions
in 1-in. increments. See figure 13.
Changing the seat height:
1. Turn the scooter off and place the manual freewheel
lever in drive mode.
2. Remove the seat and rear shroud. See IX. “Disas-
sembly and Assembly.”
3. Loosen and remove the seat height adjustment bolt,
bolt-nut and washers.
4. Slide the upper seat post up or down in the lower
seat post and align the adjustment holes on both posts.
5. With one washer on the seat height adjustment bolt,
insert it through the adjustment holes of both the
upper and lower seat posts. Reinstall the other
washer and bolt-nut and tighten.
6. Reinstall the shroud.
7. Reinstall and lock the seat into place.
32
C O M F O R T
Do not operate your
www.pridemobility.com
A D J U S T M E N T S
Figure 12A. Seatback Adjustment
Figure 12B. Armrest Angle Adjustment
WASHER
BOLT-NUT
Figure 13. Seat Height Adjustment
SEATBACK
ADJUSTMENT
LEVER
ADJUSTMENT DIAL
UPPER SEAT POST
WASHER
SEAT HEIGHT
ADJUSTMENT BOLT
LOWER SEAT POST
Legend XL