Operation - Regal Aero 3 Installation Manual And User's Manual

ENERGY FIREPLACE INSTALLATION MANUAL AND USER GUIDE
The chimney's height is relative to the diameter of the exhaust gases duct
(see table below).
CHIMNEY
exhaust
Φ200
gases DUCT
MINIMUM
3-4m 4-6m
LENGTH
MINIMUM
25X25 20X20
CROSS-
Φ25cm Φ20cm
SECTION
4.2 Caution notes
You should not pass cables or other flammable materials through the
chimney.
The chimney must be installed by trained staff and its inclination should
not be greater than 45ᵒ. Moreover, the path of the exhaust gases should
be clear of any obstacles.

5 OPERATION

5.1 Combustible materials
Well-dried firewood of low humidity is recommended for the combustion in
the energy fireplace (Note: Humidity content based on the combustion-ISO
331:1983 and ISO 687:1974. Raw wood 12% to 15% based on ΕLΟΤ
ΕΝ13229:2001)
Firewood with high humidity content and liquids can result in deposits in
the chimney interior (fire hazard), return of exhaust gases and reduced
performance of the fireplace. Use of different combustible materials than
ENERGY FIREPLACES
Φ250 Φ300
3-4m 4-6m 3-4m
25X25 20X20 35X35
Φ25cm Φ20cm Φ35cm
-SUBJECT TO CHANGE DUE TO IMPROVEMENTS
ENERGY FIREPLACE INSTALLATION MANUAL AND USER GUIDE
that mentioned above may result in damage to the fireplace itself.
Resinous wood (fir, pine, etc.) must be avoided in order to prevent the
contamination of the firebox and the ceramic glass with tar residues.
The warranty shall be invalid in case of firewood burning that does not
comply with the above specifications. The burning of painted wood, plastic
and other materials which release toxic gases and are harmful for humans
and the environment, is prohibited.
5.2 Lighting the first fire
4-6m
During the first lighting of fire at the firebox, the area of installation must be
properly ventilated. Note that you may notice smoke and intense smell due
30X30
to the fact that the protective paint needs to dry.
Φ30cm
The handles and the protective glass should be cleaned using a cleaning
cloth. Any dirt that is not removed will be burnt and leave spots which you
won't be able to remove at a later stage.
During the first two days of operation you should make cautious use of the
fireplace using only small loads of firewood, so that the different materials
of your fireplace will take their time to settle and dehumidify without being
subjected to intense thermal shock.
5.3 How to light the firebox
You should not use flammable materials (alcohol, gasoline, petrol etc.) for
lighting the firebox and you should not use water for putting out the flame.
Any damage caused by such actions is not covered by the warranty.
Make sure that the fresh air inlet damper is open. The warm air outlet on
top of the fireplace must also be open. The ventilator's switch must be on.
The size of the firewood is relative to the width and depth of the firebox's
combustion chamber (refer to the relevant table).
Through the practical use and operation of your energy fireplace, you will
be able to determine the configuration that better serves your needs.
ENERGY FIREPLACES -SUBJECT TO CHANGE DUE TO IMPROVEMENTS