Elan V85 Installation Manual page 5

E L A N H O M E S Y S T E M S
Cleaning
—Unplug the apparatus from the power outlet before cleaning. Use only a dry cloth to clean the apparatus.
Power Lines
—An outdoor antenna should be located away from power lines. When installing an outside antenna system, extreme care
should be taken to avoid touching power lines or circuits, as contact with them may be fatal.
Outdoor Antenna Grounding
is connected to these audio products, be sure the antenna or cable system is grounded
so as to provide some protection against voltage surges and built-up static charg-
es. Section 810 of the U.S. National Electrical Code, and Section 54 of the
Canadian Electrical Code, provide information with respect to proper grounding of
the mast and supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode.
See the grounding diagram (right).
Overloading
—Do not overload wall outlets and extension cords, as this could
result in fire or electric shock.
Object and Liquid Entry
openings of these appliances, as they may touch dangerous voltage points or
short-out parts that could result in a fire or electric shock. Care should be taken so that
objects do not fall and liquids are not spilled into the appliance through openings in the enclosure.
Servicing
—Do not attempt to service these appliances yourself, as opening or removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.
Damage Requiring Service
• A power supply connection or a plug has been damaged or
• If liquid has been spilled into the appliance or objects have fallen into the appliance or
• The appliance has been exposed to water or moisture or
• The appliance does not appear to operate normally or exhibits a marked change in performance or
• The appliance has been dropped or the enclosure damaged.
Replacement Parts
the manufacturer or that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other
hazards. The Master Control Unit battery should be replaced only after turning the power off and only by an authorized installer.
Safety Check
—Upon completion of any service or repairs to this audio product, ask the service technician to perform safety checks to
determine that the audio product is in proper operating condition.
Lightning Storms
—Unplug this apparatus during lightning storms or when unused for long periods of time.
Attachments and Accessories
Cart, Stand, Tripod, Bracket or Table
sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip over.
Disconnect Device
—Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
operable.
© ELAN Home Systems 2009 • All rights reserved.
—If an outside antenna or cable system
—Never insert objects of any kind through the
—These appliances should be serviced by qualified service personnel when:
—When replacement parts are required, be sure the service technician has used replacement parts specified by
—Use only attachments/accessories specified by the manufacturer.
—Use only with a cart, stand, tripod, bracket or table specified by the manufacturer, or
®
V85
INSTALLATION MANUAL
Grounding
Diagram
GROUND
CLAMPS
ELECTRIC
SERVICE
EQUIPMENT
NEC - NATIONAL ELECTRICAL CODE
CEC - CANADIAN ELECTRICAL CODE
U S
C
ANTENNA
LEAD-IN WIRE
ANTENNA LEAD-IN WIRE
(CEC SECTION 54-200)
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(CEC SECTION 54-200)
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(CEC SECTION 10-700)
(NEC ARTICLE 250, PART H)
Page III