Standalone Control Modes; Master/Slave Mode - Bargeheights BAR 252 User Manual

Standalone Control Modes

The BAR 252 has several standalone control modes that do not
require a DMX control signal.
Ensure your BAR 252 is in Standalone Control Mode:
• Press <MODE> until the Control Mode is displayed.
(
dnCo Auto SLAU
• Press <+> or <-> and select
• Press <ENTER> to confirm your change.
Select the desired Standalone function:
• Press <MODE> until the Standalone function is displayed.
– Red
CL01
– Orange
CL02
– Yellow
CL03
– Green
CL04
– Cyan
CL05
– Blue
CL06
– Pink
CL07
– Magenta
CL08
– White
CL09
– Sound Control : Color
CL10
– Random Strobe/Color
CL11
– Color Chase Segments - Speed Control
CL12
– Color Fade Random - Speed Control
CL13
– Color Random - Speed Control
CL14
• Press <ENTER> to confirm your change.
The BAR 252 also has speed control for several of the Stand-
alone Control Modes.
• Press <MODE> to display the selected speed. There are 16
speeds, from fast to slow.
SP01
Page 12
)
.
Auto
is slow – is fast.
SP16
BAR 252 User Manual rev. A

Master/Slave Mode

Up to 32 BAR 252s may be connected via the 3-pin DMX con-
nections and controlled simultaneously without a DMX control-
ler by using Master/Slave Mode. In this mode you can set one
fixture in the line to act as the master controller – and up to 32
other fixtures can be connected and will mirror the operation of
the Master.
To ensure your BAR 252 is in Slave Mode:
• Press <MODE> until the Control Mode is displayed.
(
dnCo Auto SLAU
• Press <+> or <-> and select
• Press <ENTER> to confirm your change.
To set your BAR 252 in Master Mode, set it up just as you would
for a Standalone Control Mode.
• Press <MODE> until the Control Mode is displayed.
(
dnCo Auto SLAU
• Press <+> or <-> and select
• Press <ENTER> to confirm your change.
Then you can select the function on the Master fixture and
watch the Slave fixtures follow.
©2010 Bargeheights, Inc.
)
.
SLAU
)
.
Auto
Page 13