Troubleshooting - Vinotemp VT-WINEDISP4 Owner's Manual

PROBLEMS WITH YOUR WINE DISPENSER
Most common problems can be solved easily, saving you the cost of a possible service call. Try
the suggestions below to solve the problem before contacting Vinotemp at info@vinotemp.com.
Dispensing System
Complaint
One canister only
dispensing 1 or 2
bottles, gas
leaking/escaping
Unit not
dispensing
Dispensing
interrupted or slow
Wine spurting or
spitting
12

TROUBLESHOOTING

Possible Causes
a. Canister gasket unaligned, bad or
missing
b. Canister not tightened
c. Gas tube broken
d. Gas tube not tightened at the
regulator or valve
e. Regulator leak
f. Gas valve stuck open
g. Bottle not tightened
a. Argon/Nitrogen leak
b. Defective pressure regulator
c. Bottle neck not tightened or
defective plug
d. Defective gas solenoid valve or
incorrect wiring
e. Defective wine solenoid valve
or incorrect wiring
f. Incorrect or loose wirings,
defective power board or
control board
a. Argon/Nitrogen low
b. Gas tubes kinked or twisted
c. Bottle neck not tightened
d. Gas solenoid valve restricted
e. Wine solenoid valve restricted
a. Wine tube is restricted
b. Bottle is near empty and there
is too much gas in the bottle
c. Gas pressure is too high
d. Wine solenoid valve is dirty
W W W . V I N O T E M P . C O M
Response
a. Align, change or install the gasket
b. Turn the canister clockwise all the way
c. Change the gas tube
d. Check for these connections
e. Check for gas escaping at the regulator
f. If gas continues to escape from the gas
tube, check for gas valve and wirings
g. Check the plug/fixer
a. If none of the spouts dispense wine,
check for canister pressure gauge or turn
the canister slightly counter clockwise to
see if any gas escapes (turn clockwise to
re-tighten), then check for gas leaking as
instructed above
b. If none of the spouts dispense wine and
the canister has pressurized gas, check
the regulator
c. Press dispense button to check if gas is
escaping from the plug or fixer
d. Press the dispense button to see of gas is
escaping out of the gas tube
e. Switch the questionable valve to a
working spout and check to see if problem
still exists
f. Check all wirings and connections
a. If all spouts are dispensing wine slowly,
check the gas pressure and install a new
canister if necessary
b. Press dispensing button to see if gas is
escaping out of the gas tube slowly
c. Check the bottle plug and fixer for
escaping gas
d. Remove bottle, press dispensing button
to see if gas is escaping out of the gas
tube
e. Switch the to a working spout to check
a. Check for any restrictions
b. Change the empty wine bottle out for a full
one
c. Replace the pressure regulator
d. Clean solenoid valves
1
2