Removing The Unit - Panasonic AW-HE100E Operating Instructions Manual

Removing the unit

The procedure described here applies to the removal of
the type of unit that is suspended (hanging installation), but
the same steps are performed for a desktop type of unit
(desktop installation) as well.
 Before removing the unit, turn off the circuit breaker and
other power supply controls.
 The drop-prevention wire is attached to the bottom panel
of the unit. Be careful when disengaging the unit.
 Exercise great care during the removal work to ensure
safety by providing a stepladder or other means which is
strong enough for the unit's weight and high enough for
the installation location, and ensure that the unit will not
be dropped.
 During the course of the work, be sure to hold the unit
by its base area. Removing the unit while holding it by its
lens area or rotating parts may result in malfunctioning.
 Ensure that the removal work is undertaken by a
two-member crew.
1
Remove the cable cover.
Remove the screw concealment sheets, remove the
two screws, and then remove the cable cover.
The cable cover is provided with tabs. Pull these tabs
down to remove.
2
Disconnect the cables.
Disconnect the power cable, video cable, and control
cable, etc.
Screw concealment sheet
3
Remove the four unit anchoring screws.
4
Turn the unit in the direction of the
arrow shown in the above figure, and
disengage.
5
While holding the unit, disengage the
hook of the drop-prevention wire.
Product mounting bracket
Base area
6
Remove the mounting bracket which is
attached to the ceiling.
63 (E)
Drop-prevention
wire