Panasonic AW-HE100E Operating Instructions Manual page 38

Genlock adjustment
When doing the adjustment
using the controller
The same operations as those in "When performing the
operations using the accessory wireless remote control" can
be performed following the operation procedure for "Basic
menu operations" (pages 39 to 46).
 Colour phase adjustment
The colour phase adjustment must be performed if the
pictures are to be switched using a video switcher or other
device when the video output signals have been set as
composite or Y/C signals.
It need not be performed when the video output signals
have been set as component signals.
The camera's colour phase is aligned with the programme
output (split colour bar output) signals of a colour special
effect device or other colour tones that will serve as
the reference. (The colour phase can be adjusted more
accurately if a vectorscope is used for the adjustment.)
Colour bar of camera
Split line
Colour bar of special
effects generator
37 (E)
When performing the operations using the
accessory wireless remote control
1
Press the [MODE] button.
The mode is switched to the colour bar display.
2
Set to the user mode by following the
steps in "Selecting the shooting modes
(scene files)" (page 19).
At this time, keep the "Mode Set" sub-menu on the
display.
 The colour phase adjustment is common to all
shooting modes (scene files), but when the wireless
remote control is used to perform the adjustment, the
shooting mode must be selected. For this reason,
either select the shooting mode which will be used
subsequently or select the shooting mode again
afterward.
 Halogen Mode Set 
Brightness Set
Colour Set
G/L Set
Other Set
Initialize
Return
Example: Halogen mode
3
Press the [] or [] button to make "G/L
Set" blink.
4
Press the [] or [] button.
The "G/L Set" sub-menu is displayed.
 G/L Set 
H Phase
SC Coarse
SC Fine
Return
+1
180deg
±0