Makita 9032 Instruction Manual page 7

Filing sander
Hide thumbs Also See for 9032:
Table of Contents

Advertisement

001218
I
1. Speed adjusting dial
ASSEMBLY
Speed adjusting dial
The belt speed can be infinitely adjusted between
5
m and
28 m per second (980
-
5600 ft./min.) by turning the speed
adjusting dial to a given number setting from 1 to 6.
Higher speed is obtained when the dial is turned in the direc-
tion of number 6; lower speed is obtained when it is turned in
the direction of number 1. Select the proper speed for the
workpiece to be sanded.
CAUTION:
The speed adjusting dial can be turned only as far as 6
and back to 1.
Do
not force it past 6 or 1, or the speed
adjusting function may no longer work.
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing abrasive belt
001219
Pull the cam lever all the way out. Install the belt over the rear
pulley, and slip the belt over the front pulley, with the belt
pulled out
to
the front arm. Return the cam lever
to
the origi-
nal position.
1 Arm
2 Abrasive belt
3 Cam lever
4 Rear pulley
001220
Adjusting belt tracking
Switch on the tool and make sure that the belt is aligned
properly.
Use the adjusting dial to center the belt tracking. Turn the
adjusting dial clockwise to incline the arm to the right, or
counterclockwise to incline it
to
the left.
1. Arm
2. Adjusting dial
7

Advertisement

Table of Contents
loading

Table of Contents